- #Black magic design videohub control pro for mac
- #Black magic design videohub control pro software
- #Black magic design videohub control pro free
If the computer is set to 192.168.5.100, the ATEM will need to be set to 192.168.5.XXX where XXX is any available number from 2-255, but not 100 because that's taken by the computer. Every device will have a different IP number on the same network range. When you go to change the IP information of the ATEM, here are some very basic key things to note as they relate to the computer's network information:ġ.
#Black magic design videohub control pro free
If there are several devices already on your network, you may need to talk to the network admin to determine a free spot to use for the ATEM. Go to the location mentioned above where you can see the "Internet Protocol Version 4" properties and make note of the IP information there. If this is the case, you will need to know what network the computer is already on. Now, if the computer you are using is connected to a router of some sort and you use the ethernet connection for an Internet connection as well, you may need to adjust the ATEM IP information to place it on the already existing network.
#Black magic design videohub control pro software
This should get the software talking to the hardware. You will want to tell the software it is looking for 192.168.10.240 so it knows to search for the ATEM's IP on the computer's network. This should prompt you for an IP address to point to. This will allow your Internet connection to look to your WiFi first. Under your list of connections on the left, click the gear icon and choose "Set Service Order." Drag your WiFi connection to the top. *Additional note for Mac: If you're using a WiFi Internet connection, you don't want the Ethernet connection to be seen as the primary connection. Under the Ethernet connection, you'll want to set the IP information manually: Here is information for Mac: Navigate to your System Preferences and click on Network. Click the bubble for "Use the following IP address" and type in the following information: Then click "Properties" to open the box where you can change the IP settings for this network. Single-click "Internet Protocol Version 4 (TCP/IPv4)" to highlight it.
Here is information for PC: Navigate to your Network And Sharing Center in the Control panel and find the Local Area Network. Now you'll want to change the computer's settings to be on this same network. In the ATEM Setup Utility (which is accessible if you have the USB connected to the computer) check that the IP information is as follows: The ATEM ships with a default IP address and we can set the computer's information to to be on this same network. It may seem confusing at first if you're unfamiliar with networking, but hopefully it will make more sense as you're going through the settings.įirst, let's walk through some settings if you directly connect ethernet from ATEM to computer and do not use the computer's ethernet port for an Internet connection as well.
#Black magic design videohub control pro for mac
Are you connecting the ethernet cable directly from the ATEM to the computer? Or are you running the connection through a router of sorts on an existing network? Either one would work, and I'll give you a bit of information to help in either situation for Mac and PC environments.
0 kommentar(er)
